Brass
inserts Brass Molding Inserts Brass
Plastic Molding Inserts Brass Plastic
Molding inserts Brass Injection Moulding
Inserts Brass Injection Molding Inserts
Brass roto molding Roto moulding inserts
Brass inserts for cold moulding Hot
insert molding |
Special Features :
-
Threads
as per International Go & Not Go
Standards. Brass Stainless Steel Nuts
Moulding inserts molding nuts
-
Deep Groove
for maximum Pull Out Resistance.
-
Inner Diameter
(I/D) after Threads with very close
tolerance to prevent unnecessary flush
to enter into the inserts.
-
Knurling
Available :
-
Diamond
-
Straight
-
Unidirectional
-
Both blind
and through inserts are available with
no minimum Qty.
Special Brass inserts Moulding
Inserts Molding Brass inserts Available
We shall be pleased to develop Non-Standard
Brass inserts components nuts screws
studs fixings wood screws machine screws
fasteners as per specific requirements.
Materials
Brass
to BS 2874 / 2872
Finish
Brass natural, Electro-Tinned, Nickel
etc.
Threads
ISO Metric, BSW, BA, BSF, UNC, UNF
UNEF etc.
Threads: 2mm 3mm 4mm 5mm 6mm 8mm 10mm 12mm
16mm 20mm 25mm 32mm
1/8" 5/32" 3/16" 1/4"
5/16" 3/8" 1/2" 5/8"
3/4" 1" 11/8" 11/4"
11/2" 13/4" 2"
BRASS STRAIGHT KNURLED MOULDING INSERTS
Features: They are one one thro'
hole Brass inserts. They can be
potted in or moulded. A straight knurl
offers better torque out capabilities.
Sizes: from 2mm -10mm
BRASS HELICAL MOULDING INSERTS MOLDING
NUTS
Features: They are compact inserts
suitable for insertion in all types of
plastics and can be used with hot plastic
Moulding and cold plastic molding . Inserts
are best suitable for electrical moulded
box application..
Sizes: from 2mm -12mm and 1/8"
- 1/2"
Brass Inserts for CPVC and UPVC Drainage
and Sewerage fitting Moulding
Features: These Brass inserts are
used for UPVC moulding CPVC molding for
sewerage and drainage pipe fittings elbows
and Pipe couplings .
Sizes: from 1/4"mm -3/4"
mm
BRASS INSERTS FOR WOOD AND PLASTIC
Features: These Brass inserts are
push fit type and are used with Wood and
plastic moulding. .
Sizes: from 1/4"mm -3/4"
mm
BRASS SELF TAPPING INSERTS
Features: These inserts are suitable
for installation with wide range of thermoplastics
and are sued where high pull out torque
is required.
Sizes: from 1/4"mm -3/4"
mm
BRASS KNURLED MOULDING SCREWS
Features: These screws are used for
moulding of Nylon spacers and pillars.
Sizes: from 2mm-10mm and 1/8"-3/8"
|